Extra Retraction at Start - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Can someone explain why I am getting an extra retraction command right before my skirt starts? When I print, the filament doesn't print for sometime because of the extra retraction. I have tried it in both 3.4.1 and 3.5. Maybe I have a setting that is checked or set wrong. Below is my gcode from

3D Printing Slicer Software - How to Choose the Best

Reduce or eliminate travel when retraction is not an option - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Cura retraction continuously increases exponentially during print - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Welcome to Ultimaker Cura 3. – Septillion Co., Ltd.

How to Reduce Stringing: Ender 3 Retraction Settings

Z-Seam: The 9 Best Settings to Fix & Hide It

Cura settings in 5 minutes or less! - 6.1 - Retraction

10 Good Reasons to Use Cura

Extra Retraction at Start - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Cura for Clay 3D Printing, Overview

ultimaker cura - Extruder doesn't retract on inner wall lines thereby causing stringing - 3D Printing Stack Exchange

Optimize retraction settings to prevent rework by hand after print - Improve your 3D prints - UltiMaker Community of 3D Printing Experts

Retraction: Just say No to oozing